Brainlab Robotics Hardware User's Manual page 48

Charging the Battery
Warning
Do not touch the patient and the battery charger jack or battery charger cable at the same
time.
How to Charge the Battery
Step
1.
2.
3.
4.
5.
48
Connect the Battery Charger to supply mains using the appropriate mains power cable
(country-specific power cord).
Connect the Battery Charger with its power output cable to Robotics. The Battery
Charger LED lights, indicating an active power input from the Battery Charger to Robot-
ics.
Robotics starts charging the battery indicated by the blinking of the Battery Status LED.
Once the battery is fully charged, the LED is lit continuously, indicating that the device is
fully operational.
Unplug the Battery Charger.
• Hold the cable with one hand and release the engaging teeth by pulling the spring-
loaded sleeve outwards:
Take care when unplugging the charger plug from Robotics.
• If the spring-loaded sleeve is not pulled back, the teeth protrude:
• If the spring-loaded sleeve is pulled back, the teeth retract:
NOTE: Robotics cannot be maneuvered if the Battery Charger is connected. You must
unplug the Battery Charger before patient treatment.
Hardware User Guide Rev. 1.0 Robotics Ver. 2.1