PIAGGIO Beverly 400 E5 Service Manual page 148

Engine
- Insert the oil pump driving sprocket and chain.
- fit the tensioner pad.
- place the spring washer and insert the water
pump control screw.
- Preventing rotation, tighten the water pump com-
mand screw.
CAUTION
THE THREAD IS ANTICLOCKWISE.
N.B.
FIT THE BELLEVILLE WASHER SO THAT ITS OUTER RIM
TOUCHES THE PULLEY. MAKE SURE THAT THE PUMP
TURNS FREELY.
Locking torques (N*m)
Oil pump command sprocket screw
Removal
- Before removing the flywheel cover, loosen the
impeller.
CAUTION
THE THREAD IS ANTICLOCKWISE.
CAUTION
IF THE LOCKING TORQUE IS EXCESSIVE, DO NOT INSIST
WITH THE OPERATION BUT CARRY IT OUT AFTER THE
REMOVAL OF THE FLYWHEEL COVER. AFTER REMOV-
ING THE FLYWHEEL COVER, LOCK THE IMPELLER
(DRIVE SIDE OF MOTORCYCLE) IN THE CLAMP AND,
ACTING FROM THE OPPOSITE SIDE, LOOSEN THE IM-
PELLER SHAFT (LEFT-HAND THREAD).
ENG - 148
9 ÷ 11
Beverly 400 E5