Audio - Axis Q1715 User Manual

AXIS Q1715 Block Camera
Additional settings
3. In the list of conditions, select Tampering.
4. In the list of actions, select Send notification to email.
5. Select a recipient from the list or go to Recipients to create a new recipient.
To create a new recipient, click
6. Type a subject and a message for the email.
7. Click Save.

Audio

Add audio to your recording
Turn on audio:
1. Go to Settings > Audio and turn on Allow audio.
2. Go to Input > Type and select your audio source.
Edit the stream profile which is used for the recording:
3. Go to Settings > Stream and click Stream profiles.
4. Select the stream profile and click Audio.
5. Select the checkbox and select Include.
6. Click Save.
7. Click Close.
Connect to a network speaker
Network speaker pairing allows you to use a compatible Axis network speaker as if it is connected directly to the camera. Once
paired, the speaker acts as an audio out device where you can play audio clips and transmit sound through the camera.
Important
For this feature to work with a video management software (VMS), you must first pair the camera with the network speaker,
then add the camera to your VMS.
Pair camera with network speaker
1. Go to Settings >System > Accessories > Network speaker pairing.
2. Type the network speaker's IP address, username and password.
3. Click Connect. A confirmation message appears and Use speaker pairing is turned on.
4. Go to Settings > Audio.
5. Turn on Allow audio.
6. Make sure that audio mode is set to Half duplex or Simplex - Network Camera speaker only. Otherwise, the camera will
not communicate with the network speaker.
. To copy an existing recipient, click
20
.