Additional Settings; Adjust The Image - Axis Q1715 User Manual

AXIS Q1715 Block Camera

Additional settings

Additional settings

Adjust the image

This section includes instructions about how to configure your device. If you want to learn more about how certain features
function, go to Learn more on page 22.
Level the camera
To adjust the view in relation to a reference area or an object, use the leveling guide in combination with a mechanical adjustment
of the camera.
1. Go to Settings > System > Orientation and click
2. Adjust the camera mechanically until the position of the reference area or the object is aligned with the leveling guide.
Adjust the focus
This product has three focus modes:
• Auto: The camera automatically adjusts focus based on the entire image.
• Area: The camera automatically adjusts focus based on a selected area of the image.
• Manual: The focus is set manually at a fixed distance.
To turn off autofocus and adjust the focus manually:
1. In the live view window, if the Zoom slider is visible, click Zoom and select Focus.
2. Click M and use the slider to set the focus.
Select scene profile
A scene profile is a set of predefined image appearance settings including color level, brightness, sharpness, contrast and local
contrast. Scene profiles are preconfigured in the product for quick setup to a specific scenario, for example Forensic which is
optimized for surveillance conditions. For a description of each available setting, go to the help menu
You can select a scene profile during the initial setup of the camera. You can also select or change scene profile later.
1. Go to Settings > System > Orientation.
2. Go to Scene profile and select a profile.
3. Click Done.
Reduce image processing time with low latency mode
You can optimize the image processing time of your live stream by turning on low latency mode. The latency in your live stream is
reduced to a minimum.
1. Go to Settings > System.
2. Go to Plain config > Image source.
3. Go to Low latency mode and select On.
4. Click Save.
.
8
and click Help.