Page 1
We encourage our customers to write or call for a demonstration of this equipment prior to use or for any additional information relative to use or repairs. Call 1-800-MSA-2222 during regular working hours. See separate insert for NIOSH approval information (P/N 10041484) TAL 209 (L) Rev.
INTRODUCTION TABLE OF CONTENTS Niosh Approval Information ..........2 Donning the Saranex Hood PAPR........10 Special or Critical User Instructions ........2 Donning Advantage 3000 (Model 3100) Respirator ..10 Description.................5 Donning the Respirator with Plastic Advantage Harness 10 Combination Cartridges.............5 Replacing the Filter, Chemical Cartridges, or Principle of Operation............5 Combination Cartridges, and Battery Pack.....11 Unpacking and Inspection..........7...
Page 3
(NIOSH) only as a guide to proper evaluation of the many cont- American Industrial Hygiene Association (AIHA) aminants found in industry. Contact MSA for further Contact MSA at 1-800-MSA-2222 for information. information on other specific material. Exposure Limits for Mixtures 5.
Page 4
INTRODUCTION 7. This respirator may not provide a satisfactory seal WARNING with certain facial characteristics, such as beards Do not use for urethane paints or other paints contain- or large sideburns, that prevent direct contact ing diisocyanates unless an appropriate cartridge between the skin and the sealing surface of the change-out schedule is developed.
Air flow also provides wearer comfort. The OptimAir 6HC combination cartridge may be used The OptimAir 6HC PAPR is powered by a Lithium battery with the Saranex Hood, or the Advantage 3000 (Model pack. The Lithium battery is NOT rechargeable; however, 3100).
When the pack reaches the end of its life, dispose reduced, the entire motor-blower must be returned to of it according to appropriate disposal procedures. MSA or an authorized MSA Service Center for repair. WARNING Do not recharge a Lithium battery. The Lithium battery REMOVING AND INSTALLING COMBINATION can explode.
SARANEX HOOD ASSEMBLING THE SARANEX HOOD PAPR INSTALLING THE HOOD SUSPENSION 1. Remove the suspension by pulling the Velcro ® strips Note: If the optional chin strap will be used, install it at apart, then pull the suspension out of the hood. this time.
MSA or an authorized MSA Service Center for repair. 4. Tighten the two bottom straps so that the mask is snug against the face. The top two harness straps 2.
Chemical Agent Safety and Health Policy Action Committee (CASHPAC). This gas mask also has been tested by MSA and found to be WARNING effective against OC (Oleoresin Capsicum) Riot Control Return to a safe atmosphere and discard the respira- Agent and HCN (Hydrogen Cyanide).
The service time data presented in this investigation 1. A decontamination procedure for the user and the applies only to MSA respirators. It should be used as a protective equipment should be developed and guide only for determining an appropriate respirator car- implemented.