Table of Contents
Advertisement
hs dock
Removal
10.3 Removal of the product
10.3.1 Removal of the hydraulic port variant of the product to the underside of
the product
68
A
Expander
B
Cap plug
B1
Cap plug seals
C
Swivel joints
D
Screw plugs
D1 Screw plug seals
E
Product
E1
Fixing screws on the product
E2
Transport thread on product
F
Spacer [on tandem version]
G
Clamping bracket
a
Test surface, product face run-out
b
Test surface, position product
The product can be connected to the hydraulic supply on the
machine in two different ways.
Either to the machine using the hydraulic ports on the under-
side of the product, if necessary with a base plate. Or the
product can be connected to the hydraulic supply using its
side ports.
1.
As described in the »Preparing the machine for re-
moval« chapter, prepare for the following steps.
1.
Move the product into its rear limit stop position.
2.
Depressurize the hydraulic unit.
3.
Attach any lifting gear that may be required.
4.
If necessary, fit the mounting aid onto a vertically sus-
pended spindle.
Order hotline +49 7144.907-333
Advertisement
Table of Contents
