Names Of Parts; Jm-103 Main Body - Konica Minolta JM-103 Instruction Manual

Names of Parts

1) JM-103 main body

READY lamp
Lights up to indi-
cate that the in-
strument is ready
for the next mea-
surement.
Display
Displays the mea-
sured value etc.
❋For the method
o f r e a d i n g t h e
display, refer t o
" R e a d i n g t h e
Display" on page
12
Measuring probe
Takes measurement
when pressed against
the measuring point.
10
POWER switch
• Slide this switch to turn the power ON/
• Using this switch in combination with
Charger contact
Used to connect the
Charger unit.
OFF.
the RESET button allows you to switch
to check mode and change the unit of
measurement.
• Deletes the currently displayed
measured value and prepares for
the next measurement.
• Using this switch in combination
with the POWER switch allows
you to switch to check mode and
change the unit of measurement.
• In addition, holding this button
down allows you to set the num-
ber of average measurements to
be performed.
Strap attach-
ment area
Attach the strap.
RESET button