Typical Installation; Pump Location - Franklin Electric BT4 Series Owner's Manual

INSTALLATION

Typical Installation

Pump Installation Using Municipal Source
Street Supply
Union
Valve (normally open)
Check Valve
Union
Pressure Gauge
Service Tee
Inlet
Pressure Tank
Pressure Gauge
Booster Pump
Outlet
Union
Pressure Relief Valve
Pump Installation Using Wall Hydrant or Faucet
Wall Hydrant
High Pressure Reinforced Hose
Hose Adapter
Booster Pump
Spray Nozzle
High Pressure Reinforced Hose

Pump Location

• Install the pump in a clean, dry, and ventilated location shielded from direct sun and precipitation.
• Provide adequate room for future servicing, protection from freezing temperatures, flooding, and
equipment drainage.
• Bolt unit down evenly on a good foundation, preferably concrete, to prevent unnecessary stresses
from pump movement.
• Install as close as possible to water source to minimize suction piping length.
Check Valve
Valve (normally open)
Union
Pressure Switch
Drain Valve
Pressure Gauge
Service Tee
Discharge Outlet
Suction Inlet
Pressure Relief Valve
Hose Adapter
Typical Installation
Pump Installation Vertical On Wall
To Power
Male Pipe to Male Hose Adapter
(Suction)
Male Pipe to Male
Hose Adapter
(Discharge)
Female Hose
Connection
Pump Installation Drawing Water from Below Pump
Priming Plug
Tee 90 Elbow
To Power
10 Feet
Maximum
Water Supply
Foot Valve
INSTALLATION
Service Line
Gate Valve or Hose Bibb
Male Pipe to Male Hose Adapter
High Pressure Hose with two
Female Connections
Gun Nozzle
Weeping Type ONLY
High Pressure Hose
Male Pipe to Male Hose Adapter
Female Hose
Connection
High Pressure
Hose
Male Hose
Connection
Gun Nozzle
Weeping Type ONLY
3