Table of Contents
Advertisement
Available languages
Available languages
SAFETY INSTRUCTIONS
Specifications
Risk of severe injury or death by electrical shock.
•
To reduce risk of electrical shock, disconnect power before working on or around the system. More than one disconnect switch
may be required to de-energize the equipment before servicing.
•
Wire pump system for correct voltage.
•
Be certain that this pump is connected to a circuit equipped with a ground fault circuit interrupter (GFCI) device if required by
code.
•
The pump includes a grounding connector. To reduce risk of electric shock, be certain that it is properly connected to ground.
•
To avoid hazards when installing or servicing, install a double-pole disconnect near the pump installation.
•
Use an appropriate discharge resistor to discharge the capacitor prior to working on the motor.
•
Check local electrical and building codes before installation. The installation must be in accordance with their regulations as well
as the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA), or Canadian Electrical
Code (CEC).
Risk of bodily injury, electric shock, or equipment damage.
•
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experi-
ence and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with the unit or in
the immediate vicinity.
•
Do not run the pump dry. If run dry, the surface temperature of the pump will rise to a high temperature that could cause skin
burns if touched and will cause serious damage to your pump.
•
Equipment can start automatically. Lockout-Tagout before servicing equipment.
•
The pump has been evaluated for use with water only. Pump should only be used with liquids compatible with pump component
materials.
•
An inoperative or malfunctioning pump could lead to flooding, resulting in personal injury or property damage.
•
Pump may become hot during operation. Allow pump to cool before servicing.
•
Operation of this equipment requires detailed installation and operation instructions provided in this manual. Read entire manual
before starting installation and operation. End User should receive and retain manual for future use.
•
Keep safety labels clean and in good condition.
•
Keep work area clean, well-lit, and uncluttered.
•
Wear safety glasses while installing or performing maintenance on the pump.
2
Advertisement
Table of Contents
