PIONEER DJ AlphaTheta CDJ-3000 Service Manual page 41

5
Direction Lever
g
! Depending on the status of the direction lever switch, [FWD], [REVERSE] or [SLIP REVERSE] will be displayed
in the "CURRENT VALUE". When all three status are detected, [OK] is displayed in the "RESULT".
g SD Card Switch
! Depending on the status of the SD Card Switch, [OPEN] or [CLOSE] will be displayed in the "CURRENT VALUE".
If both status are detected, [OK] is displayed in the "RESULT".
g Analog Operators (Encoder, Tempo Slider, Vinyl Speed Adjust Knob)
! Current analog value of each operator is displayed in the "CURRENT VALUE".
! If you move the operators, the current value change according to the change in the value.
! When the value of both ends are detected in each operator, [OK] is displayed in the "RESULT".
g JOG Dial
! JOG TOUCH SW: "ON" is displayed while you touch JOG dial.
! JOG ROTATION: The rotation direction of JOG is displayed.
! The JOG LED in white lights on during forward rotation, and the JOG LED in red lights on during reverse rotation.
[Mode 5/10] TOUCH PANEL CHECK
[Touch Panel Check]
! You can check accuracy of the touch panel. Touch the quadrangle at the four corners to turn it blue.
(You should use a pointed touch pen.)
! When all the quadrangles are touched, [OK] is displayed on the display.
! If you touch a place other than quadrangles, "+" symbol is displayed on the place you touched.
[Touch Panel Calibration]
5
6
CDJ-3000
6
7
7
8
A
B
C
D
E
F
41
8