PIONEER DJ AlphaTheta CDJ-3000 Service Manual page 25

5
2
Remove the Jog Assy from the Control panel Section.
2-1 Remove the Knob.
2-2 Remove the 6 screws and then disconnevct the each FFCs and connectors.
2-3 Remove the 8 screws and then remove the Jog Assy.
3 Remove the JOG LCD Assy from the Jog Assy.
3-1 Remove the Holder (DNK6780) and separate the top and bottom.
* Removing JOGB and CONB Assys earlier.
3-2 Remove the four screws, and separate the touch part.
3-3 Remove the four screws, disconnect the 2 pin connectors between the JLCD Assy and the COIL1 Assy, and remove the JOG LCD
Assy.
5
6
CDJ-3000
6
7
* If the white shaft (DNK6785) is attached to
DIAL Assy, remove it with tweezers and
attach it to HOLDER Assy.
(The shaft may fall off when you check
OUTER later)
7
8
A
B
C
D
E
F
25
8