Table of Contents
Advertisement
R R e e m m o o v v a a l l a a n n d d I I n n s s t t a a l l l l a a t t i i o o n n o o f f L L o o a a d d C C h h a a i i n n
Brake Adjustment
To adjust brake, insert screwdriver through hole in housing cap. Turn screw (37701) counterclockwise to tighten
brake, clockwise to loosen brake.
Brake adjustment should be made with air turned on and with rated load attached to lower hook. Operate hoist to
raise load applying slight pressure to pendant control. If load starts to lower before it is raised by motor, tighten
brake until no slippage is evident. Care should be taken not to tighten brake more than necessary to hold load. If
brake is too tight, it will cause erratic hoist control.
14
Figure 8. MHP3429
CHAIN WELD
POCKET WHEEL
CHAIN GUIDE
Figure 9. MHP3430
Advertisement
Table of Contents
