Ds0 Blocking - ADTRAN HDSL 3192 HTU-C Installation And Maintenance Practice

Appendix B

DS0 Blocking

ADTRAN has implemented the DS0 blocking feature enabling the HDSL system to remain
transparent to customer data. This allows ADTRAN products to comply with the transparency
requirements of Bellcore TA-NWT-001210. However, when the circuit is provisioned for ESF
operation, this transparency results in a condition described below.
If a customer of a Fractional T1 service fills any of the unused DS0 channels with information
other than an all 1s idle code, the ADTRAN HDSL system blocks this information from
reaching the remote end of the circuit. This forces information in those DS0 channels to be an
all 1s idle code.
The result of this blocking is that the CRC checksum delivered to the remote end will not
match the checksum calculated by the remote T1 CSU. This implies errors are being made on
the loop when actually the blocking function created the CRC errors. Enabled DS0 channels
pass error-free.
In order to avoid this condition, Fractional T1 customers are encouraged to fill the unused
timeslots with an idle code. This is a common capability on Fractional T1 CSU/DSU, D4
channel banks, and other CPE devices capable of connecting to Fractional T1 service.
61247004L1-5A B-1