Table of Contents
Advertisement
THIS FIXTURE IS COMPOSED OF SOPHISTICATED ELECTRONIC COMPONENTS. TO GUARANTEE
SMOOTH OPERATION, IT IS IMPORTANT TO FOLLOW ALL INSTRUCTIONS AND GUIDELINES IN
THIS MANUAL. ADJ PRODUCTS, LLC IS NOT RESPONSIBLE FOR INJURY AND/OR DAMAGES
RESULTING FROM THE MISUSE OF THIS FIXTURE DUE TO THE DISREGARD OF THE INFORMATION
PRINTED IN THIS MANUAL. ONLY QUALIFIED AND/OR CERTIFIED PERSONNEL SHOULD PERFORM
INSTALLATION OF THIS FIXTURE AND ONLY THE ORIGINAL RIGGING PARTS INCLUDED WITH THIS
FIXTURE SHOULD BE USED FOR INSTALLATION. ANY MODIFICATIONS TO THE FIXTURE AND/OR
THE INCLUDED MOUNTING HARDWARE WILL VOID THE ORIGINAL MANUFACTURER'S WARRANTY
AND INCREASE THE RISK OF DAMAGE AND/OR PERSONAL INJURY. ONLY CERTIFIED PERSONNEL
SHOULD PERFORM INSTALLATION OF THIS FIXTURE.
•
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED.
•
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT.
•
DO NOT ATTEMPT ANY REPAIRS YOURSELF, AS DOING SO WILL VOID YOUR MANUFACTURER'S
WARRANTY. DAMAGES RESULTING FROM MODIFICATIONS TO THIS FIXTURE AND/OR THE
DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN THIS MANUAL VOID THE
MANUFACTURER'S WARRANTY AND ARE NOT SUBJECT TO ANY WARRANTY CLAIMS AND/OR
REPAIRS.
•
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
•
NEVER OPEN THIS FIXTURE WHILE IN USE!
•
UNPLUG POWER BEFORE SERVICING FIXTURE!
•
NEVER TOUCH FIXTURE DURING OPERATION, AS IT MAY BE HOT!
•
KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!
•
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE!
•
RETINA INJURY RISK - MAY INDUCE BLINDNESS!
•
SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
•
INDOOR / DRY LOCATIONS USE ONLY!
•
DO NOT EXPOSE FIXTURE TO RAIN AND MOISTURE!
•
MINIMUM DISTANCE TO OBJECTS/SURFACES IS 6.6 FEET (2 METERS)
•
MINIMUM DISTANCE TO FLAMMABLE MATERIALS FROM THE SURFACE IS 1.6 FEET (0.5 METER).
•
DO NOT TOUCH the fixture housing during operation. Turn OFF the power and allow approximately 60
minutes for the fixture to cool down before serving.
•
DO NOT shake fixture, and avoid brute force when installing and/or operating fixture.
•
DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power cord
connectors are damaged and do not insert into the fixture securely with ease. NEVER force a power cord
connector into the fixture. If the power cord or any of its connectors are damaged, replace it immediately
with a new one of the same power rating.
•
DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never blocked. Allow
approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
•
When installing fixture in a suspended environment, always use mounting hardware that is no less than
M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
•
Always disconnect fixture from main power source before performing any type of service and/or cleaning
procedure.
•
Only handle the power cord by the plug end. Never pull out the plug by tugging the wire portion of the
cord.
•
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the fixture.
This is a normal process and is caused by excess paint in the interior of the casing burning off from the
heat associated with the lamp and will decrease gradually over time.
•
Consistent operational breaks will ensure fixture will function properly for many years.
•
Only use original packaging and materials to transport the fixture in for service.
SAFETY GUIDELINES
7
Advertisement
Table of Contents
