Table of Contents
Advertisement
Mounting Instructions
ELECTRONIC SOAP DISPENSERS
STS2520, STS1020
FOR THE WALL MOUNTED UNIT
1.
Drill a hole (24 to 25mm) at the desired
location for the soap dispenser spout
installation.
2.
Remove the hexagonal nut and the disk
from the base of the soap dispenser
spout.
3.
Insert the soap dispenser base.
4.
Insert the anti-rotation pin into the small
hole.
5.
Fix the base behind the wall with the
hexagonal nut and the disk.
•
Refer to the following diagram for the
pump installation.
*Use 350Kpa pressure reducing valve for extended life and better operation
16
FOR THE BENCH MOUNTED UNIT
1.
Drill a hole (32mm) in the counter top.
2.
Remove the locknut and
sensor cable followed by the flexi tube
through the tap hole. Finally, insert the
tap body.
3.
Replace lock nut and fasten to the
bench / Basin.
PUMP INSTALLTION DIAGRAM
For all Units
Allowance
for service
Maximum
extension of the
Soap dispenser
connector to the
pump
Minimum
clearance
from the floor
Insert the
Advertisement
Table of Contents
