Table of Contents
Advertisement
Remote Functions
Before set up make sure:
•
To use good quality AAA batteries.
Fit the batteries into the remote and
secure cover on the remote in place.
•
Ensure that the LED light on the control
blinks when any button is pressed.
•
Direct the front of the remote at the
sensor within 50 -100mm and press
relevant button to change the setting to
Functions
STS9006
Adjusting
Controller
Set
Product
Type
Button 1
Button 2
Button3
Button 4
Button 5
*Use 350Kpa pressure reducing valve for extended life and better operation
10
Grey Remote
Sensor Range and Time
Adjustment.
*Sensor Adjustment range
<100mm up to 200mm
Increase the sensor distance
( 1cm-2cm increments)
Decrease the sensor distance
( 1cm-2cm increments)
*Before using buttons 3 or 4,
First select the Mode (with the
black remote 2)
Increase the run timing
Decrease the run timing
Deactivate / Activate Sensor
suit your desired need.
•
Every time you press a button on the
Remote controller, the indicator LED light
turns on, this indicates you have made a
change. Wait at least 2 sec between every
adjustment.
•
Default Settings
Automatic ON/OFF, 2 Sec Run Time
Wave ON/OFF, 15 Sec Run Time
Black Remote
Selection Mode
Activate Automatic ON/OFF
( 2sec run time)
Activate Wave ON/OFF (15 sec run time)
Increase time between Hygiene flush
Decrease time between Hygiene flush
Hygiene Flush on/off
Advertisement
Table of Contents
