Titan TTB775VAC Manual page 31

TTB775VAC by TITAN
> Press the on / off switch (1) to position O to switch the product off.
> Remove the attachment fitted onto the hose handle (13a) / extension tube (14).
> Disassemble the tank (3) in reverse order of assembly and disconnect the hose
(13) / extension tube(s) (14), according to the product configuration.
> Replace the dust bag (19) with a new one, if necessary.
> Check and tap the hose (13) / extension tube(s) (14) to remove dust and / or
debris.
> Re-fit the suitable accessories and attachments before resuming operation.
> Press the on / off switch (1) to position I to switch the product on and let it run
idle for 15 seconds to ensure blockage has been removed.
Dust bag
> Switch the product off and disconnect it from the power supply.
> Remove the motor unit (7) in reverse order of assembly, disconnect the dust
bag (19) from the inner opening of the air inlet (6) and remove it carefully from
the tank (3).
> Assemble a new dust bag onto the air inlet of the tank. Ensure the connection is
properly sealed.
> Refit the motor unit (7) and secure the connection with the tank (3) before
resuming operation.
Cartridge filter
> Unlock the clasps (2) and remove the motor unit (7) from the tank (3).
> Turn the motor unit (7) upside down and remove the cartridge filter (18) from the
motor unit (7).
> Tap the cartridge filter (18) on a solid surface to remove dust. Replace it with
new one if worn or after heavy use if necessary.
> Wash the cartridge filter. Once completely dry, refit the cartridge filter onto the
motor unit.
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean the dust bag as they might be harmful
to its surfaces/material.
Care and maintenance
31