Wet Vacuuming - Titan TTB775VAC Manual

TTB775VAC by TITAN

Wet vacuuming

> During wet vacuuming, check the water level in
the tank regularly. The water level should
be below the air inlet (6) (Fig. 22). Empty the
tank (3) regularly if large quantities of water are
vacuumed.
WARNING! Do not overfill the tank (3) (max 12 litres)!
Do not fill with any other liquids than water as they might be harmful to
the product attachments and surfaces.
Blowing
This product is designed for light blowing. This operation requires some
accessories and attachments. Consult the section Product configurations for
details.
> Before operation, loosen leaves that are stuck to the ground using a broom or rake.
> Assemble the product according to the desired operation.
> Attach the extension tube(s) (14) onto the hose handle (13a) if required.
> Attach the desired attachment onto the hose handle /
extension tube.
> Switch the product on and hold the hose handle firmly.
> Hold the hose approximately 10 cm above the ground
and walk slowly forward using a sweeping motion from
side to side (Fig. 23).
> While working, ensure that the product does not strike
hard objects, as this can cause damage.
After use
> Switch the product off and disconnect it from the power supply.
> Disconnect the respective attachment, extension tube(s) (14) and hose (13) if
necessary.
> Let the product cool down.
> Check, clean and store the product as described below.
Operation
6
3
Fig. 22
Fig. 23
29