Heinner HWDM-V7512D Manual page 38

www.heinner.com
XIII. AUTOMATIC FAULT WARNINGS AND WHAT TO BE DONE
Your machine is equipped with a built-in fault detection system, indicated by a
combination of flashing wash operation lights. The failure codes are shown below.
TROUBLE CODE
E01 The door of your machine is left open.
The water pressure or the water level
E02
The pump is faulty or pump filter is
E03
clogged or electrical connection of the
Your machine has excessive amount of
E04
POSSIBLE FAULT
inside the machine is low.
pump is faulty.
water.
7/5Kg, 220-240V~50Hz, 1200rpm
WHAT TO DO
Shut the door properly unitl you hear the click. If the fault
persists, turn off your machine, unplug it and contact the
nearest authorised service immediately.
Check that the cold water tap is fully turned on and that
mains water is not cut-off. If the fault persists, your
machine will stop automatically. Unplug the machine,
turn off the cold water tap and contact the nearest
authorised service.
Clean the pump filter. If the problem persists, contact the
nearest authorised service. (*)
Your machine will automatically drain the water. Turn off
your machine and unplug it. Turn off the cold water tap and
contact the nearest authorised service.
37