Heinner HWDM-V7512D Manual page 33

www.heinner.com
•
A second water inlet filter is located in the tap end of the water inlet hose. To
remove the second water inlet filter, use a pair of long-nosed pliers to gently pull
on the plastic bar in the filter.
•
Clean the filter thoroughly with a soft brush and wash with soapy water and rinse
thoroughly. Re-insert the filter by gently pushing it back into place.
CAUTION: The water inlet filters can become clogged due to water quality or lack of
required maintenance and may break down. This may cause a water leak. Any such
breakdowns are out of the scope of the warranty.
Detergent Drawer
The use of detergent may cause residual build up in the detergent drawer over
time. We recommend that you remove the drawer every 2 months to clean the
accumulated residue.
To remove the detergent drawer:
•
Pull the drawer forwards until it is fully extended.
•
Gently press down on the detergent drawer (as shown above) and pull the drawer
from its housing.
•
Clean the drawer with water and a soft brush.
•
If there is any residue in the drawer housing, remove with a soft brush. Take care
to prevent any residue from dropping into the machine.
•
Dry the drawer thoroughly and slide it back into the housing
Note: Do not wash your detergent drawer in dishwasher.
Fluid detergent level plate (*)
Remove the fluid detergent level plate for cleaning and maintenance purposes, as
shown and wash off any detergent residue. Slide the fluid detergent level plate
back into the guides. Make sure that there is no remaining detergent residue.
(*) Specifications may vary depending on the product purchased
7/5Kg, 220-240V~50Hz, 1200rpm
.
32