Heinner HWDM-V7512D Manual page 34

www.heinner.com
Pump Filter
The pump filter system in your Washer Dryer prolongs the life of the pump by
preventing lint from entering your machine. We recommend that you clean the
pump filter every 2 months.
The pump filter is located behind the cover on the front-lower right corner.
To clean the pump filter:
1. You may use the washing powder spade (*) supplied with your machine or liquid
detergent level plate to open the pump cover.
2. Lodge the end of the powder spade or liquid detergent level plate in the opening
of the cover and gently press backwards. The cover will open.
3. Pull the black rubber hose forward and detach it from its clamp, place a container
under it and remove the plug from the hose.
4. Collect the water drained from your machine in a container.
5. Loosen the filter cover by turning it anticlockwise and remove by pulling.
6. Remove any foreign materials from the filter with a soft brush.
7. After cleaning the filter replace the filter cover and tighten by turning clockwise.
8. Please note that the filter cover may leak water unless re-fitted properly.
9. Close the filter cover.
When closing the pump cover, ensure that the mountings inside the cover
meet the holes on the front panel of the machine.
NOTE: Depending on the amount of water inside the machine, you may have to
empty the water collection container a few times.
Once the water has fully drained, fit the
Fit the hose back into the clamp.
7/5Kg, 220-240V~50Hz, 1200rpm
plug back on the hose.
33