Restart Rm-2 Wireless - Wolf RM-2 Installation And Operating Instructions Manual

Appendix
10.1.2

Restart RM-2 Wireless

Activate pairing mode. Pairing mode will be activated 2 seconds
6)
after a restart if the RM-2 Wireless has not been paired with a
Base Wireless. A moving rectangle will be displayed to indicate
that pairing mode is active. Pairing mode will be active for 2
minutes.
Pairing OK. Units were successfully paired (see additional
6!
information in the Base Wireless instructions!).
Initialising the heating/ventilation system. Once the Base Wireless
6@
has been paired with the RM-2 Wireless, the RM-2 Wireless will
wait for the Base Wireless to provide information about the eBUS
system. A moving rectangle and the current FW version of the
RM-2 Wireless will be displayed while it is waiting.
Pairing failed. Pairing was not successful. You will need to restart
6#
the RM-2 Wireless to reactivate pairing mode.
42 | WOLF GmbH 3066510_202108