Battery Power; Power Supply Unit (9 Vdc) - Wolf RM-2 Installation And Operating Instructions Manual

Installation and electrical connection
3.3.3

Battery power

To power the RM-2, place the 3 AAA batteries in the battery
compartment. Make sure that they are inserted correctly!
Fig. 3.3
Battery compartment
q
The RM-2 Wireless can then be placed on the four fixing hooks of
the wall retainer ("put in place and pushed downwards").
3.3.4

Power supply unit (9 VDC)

If necessary, the RM-2 Wireless can also be powered using a 9 V DC
power supply (not included, minimum 500 mA; suited for continuous
operation) instead of the 3x AAA batteries (not both at the same
time). The wall retainer for the RM-2 Wireless includes a plug-in
connector for this purpose:
Fig. 3.4
9 V DC terminals (protected against polarity reversal)
q
► Push the terminals with a screwdriver to insert the cable
Once the electricity has been connected, the RM-2 can be placed on
the four fixing hooks of the wall retainer ("put in place and pushed
downwards").
12 | WOLF GmbH
Battery compartment
Power connection
q
q
3066510_202108