Operation - Makita TD126D Instruction Manual

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing driver bit or
socket bit
► Fig.5
Use only bits that has inserting portion shown in the
figure.
For tool with shallow bit hole
Use only these type of bit. Follow the
A=12 mm
procedure (1).
B=9 mm
(Note) Bit-piece is not necessary.
For tool with deep bit hole
A=17 mm
To install these types of bits, follow
the procedure (1).
B=14 mm
To install these types of bits, follow
A=12 mm
the procedure (2).
B=9 mm
(Note) Bit-piece is necessary for
installing the bit.
Procedure (1)
► Fig.6: 1. Bit 2. Sleeve
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
Procedure (2)
In addition to the procedure(1) above, insert the bit-
piece into the sleeve with its pointed end facing in.
► Fig.7: 1. Bit 2. Bit-piece 3. Sleeve
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
• After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook (Optional accessory)
► Fig.8: 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.

OPERATION

► Fig.9
CAUTION:
• Do not cover vents, or it may cause overheating
and damage to the tool.
► Fig.10: 1. Vent
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
.
N m
(kgf.cm)
Fastening time
.
N m
(kgf.cm)
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
7 ENGLISH
Standard bolt
(S)
High tensile bolt
Fastening time (S)