Operation - Makita DTL060 Instruction Manual

Reversing switch action
► Fig.6: 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
• Always check the direction of rotation before

operation.

• Use the reversing switch only after the tool
comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may dam-
age the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing driver bit
► Fig.7
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
► Fig.8: 1. Bit 2. Sleeve
For tool without sleeve to retain
the bit
► Fig.9
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
Use insert bits shown in the figure. To install the bit, just
insert it into the spindle.
► Fig.10: 1. Insert bit 2. Spindle
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
Hook (Accessory)
CAUTION:
• When installing the hook, tighten the screw
firmly. Failure to do so may cause the breakage
of the tool or personal injury.
► Fig.11: 1. Groove 2. Screw 3. Hook
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Adjusting the angle head
The angle head can be adjusted 360°(8 positions in
45-degree increments). To adjust it, loosen the hex bolt
and remove the angle head.
Adjust the angle head to the desired position and rein-
stall it so that the teeth on the housing will match up
with the grooves in the angle head. Then tighten the hex
bolt to secure the angle head.
► Fig.12: 1. Hex bolt 2. Angle head
► Fig.13: 1. Groove 2. Tooth
Straight head and ratchet head
(Accessory)
Straight heads and ratchet heads are available as
optional accessories for various applications on the job.
► Fig.14: 1. Straight head
► Fig.15: 1. Ratchet head
OPERATION
N m
(kgf cm)
50
(510)
40
(408)
30
(306)
20
(204)
10
(102)
0
0
Fastening time
7 ENGLISH
Standard bolt
M12
(M12)
M10
(M10)
M8
(M8)
1
3
2
(S)