danalock BTZES 100 Quick Start

POL_BTZES100
Z-Wave Door Lock with Bluetooth and Turn Piece
Firmware Version : 2.4
Quick Start
A This is a Z-Wave actor. To confirm Inclusion and Exclusion press and hold the User Button on the door lock until it beeps twice.
Please refer to the chapters below for detailed information about all aspects of the products usage.
Product description
The BTZES 100 Danalock is a smart lock from Poly Control to upgrade your existing door lock. You will need no more key to lock or
unlock your door. With the Danalock you can control your door lock with a Z-Wave Controller or via Z-Wave Gateway with your
Smartphone. Additionally you can use Bluetooth to control your door lock. You only need to install the free Danalock app for your
smartphone (Android or IOS). From insde the room you can conventionally operate the lock with a turn piece or by touching the
user button.
Within the scope of delivery you will get a Danalock cylinder to replace the existing cylinder of your door lock. You will also get the
main device with the battery and the assisted motor and a screwdriver for mounting. The cylinder is applied for european doors.
Scope of Delivery:
Danalock main device
Danalock cylinder
adapter piece
screwdriver
Installation Guidelines
The BTZES 100 smart lock is for indoor use only. It is installed at the inner side of the door and replaces the normal lock cylinder.
Open the battery cover with a flat screw driver and remove the turn piece part by pulling it gently from the main device.
Plug the battery into the battery port.
Remove the old lock cylinder by removing the fixing screw on the side and pulling out the cylinder with inserted key.
Insert the Danalock cylinder and mount it with the fixing screw.
Attach the adapter piece on the inside of the room with the two grabbing screws to cover the cylinder.
Mount the Danalock main device. Fit the tailpiece over the slide for correct operation of the door lock.
Fix the danalock with the screws in the adapter piece.
Refit the two covers. Make sure the slide fits over the tailpiece.
Behavior within the Z-Wave network
I On factory default the device does not belong to any Z-Wave network. The device needs to join an existing wireless network to
communicate with the devices of this network. This process is called Inclusion. Devices can also leave a network. This process is
called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller will be turned into
exclusion respective inclusion mode. Please refer to your primary controllers manual on how to turn your controller into inclusion
or exclusion mode. Only if the primary controller is in inclusion or exclusion mode, this device can join or leave the network.
Leaving the network - i.e. being excluded - sets the device back to factory default.
If the device already belongs to a network, follow the exclusion process before including it in your network. Otherwise inclusion of
this device will fail. If the controller being included was a primary controller, it has to be reset first.