D O-It-Yourself Maintenance - Thermador PDR304 Care And Use Manual

https://appliancetechmanuals.com
SECT I ON SI X :
D O- IT- YOU RSELF M A IN TEN A N CE
OVEN LIGH T BULB REPLACEMEN T
Replace only with a 5-watt, halogen appliance light bulb. D O N O T USE a
standard household light bulb in any oven.
T O REPLACE T H E LIGH T BU LB:
1. Turn oven light switch to the off position. Let bulb and cover cool
completely.
2. Remove the light cover.
3. Remove the burned-out bulb.
appliance light bulb only. Don't touch bulb with greasy fingers.
Follow bulb manufacturer's instructions.
4. Replace cover. Turn circuit back on, if need be. (See Caution.)
POW ER FAILU RE
In the event of a power failure, only the standard burners
can be lighted manually. It is necessary to light each
standard burner individually.
If the cooktop is being used when the power failure
occurs, turn all of the burner control knobs to the
position. Then, the standard burners can be lighted by
holding a match at the ports and turning the control knob
H I
to the position. W ait until the flame is burning all the
IN T ERMIT T EN T OR CON ST AN T IGN IT ER SPARKIN G
Intermittent or constant sparking of the sealed gas surface burners can result from a number of preventable
conditions. Eliminate these conditions as indicated in the chart.
SYMPT OM
Intermittent sparking
Constant Sparking
More user manuals on
CARE AN D MAIN TEN AN CE
Replace it with a 5-watt halogen
CAU SE
• Improper fit of burner cap onto
burner base.
• Ceramic igniter is wet or dirty.
• Burner ports are clogged.
• Range is not properly grounded.
• Electrical power supply is
incorrectly polarized.
ManualsBase.com
way around the burner cap before adjusting the flame to
the desired height.
The two ExtraLow
used during a power failure. Be sure to turn them
O FF
if a power failure occurs, as they will not turn back on until
both control knobs are turned
on again. See "W hat to do if you Smell Gas", inside front
cover.
REMEDY
•
•
•
•
•
Page 42
!
CAUT ION :
Before replacing the light bulb,
O ven Light
be certain the
Switch off
is in the
Let bulb and cover cool com-
pletely before touching.
light bulb glass comes loose
from the base, turn the
power to the oven OFF at
the circuit breaker panel,
before attempting to re-
move the bulb base from
the socket.
®
burners on the far left side, cannot be
O FF
and then turned back
Align burner cap properly
on burner base.
Carefully dry or clean igniter.
Clean ports on flame spreader
with a wire, a needle or
straightened paper clip.
Refer to Installation Instructions.
H ave a qualified electrician
ground the range properly.
Refer to Installation Instructions.
H ave a qualified electrician
ground the range properly.
position.
If the
O FF