Table of Contents
Advertisement
Specifications
ERADICATOR O3 IRON REMOVAL SPECIFICATIONS
MODEL
FACTORY PRESET MINUTES
Backwash Minutes
Rinse DN Minutes
Draw DN Minutes
*Water Usage (Gallons)
Media, Cubic Feet
Mineral Tank Dimension
Drain Line Flow Control (GPM)
Injector
Max. Service Flow Rate @15 psi loss (GPM)
Max. Iron Concentration (PPM)
Max. Hydrogen Sulfide Concentration (PPM)
pH Range
Max. Manganese Concentration (PPM)
Max. Capacity Between Regen Cycles (GAL)
Based upon 50 psi water pressure
Do not use Eradicator with Ozone filter on chlorinated water supplies.
For levels higher than the maxium concentrations listed, contact manufacturer. Local water
conditions may require different application parameters.
All electric and plumbing must be done in accordance with local codes.
This system has been tested according to NSF/ANSI 42 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a
concentration less than or equal to the permissible limit for water leaving the system, as specified in
NSF/ANSI 42.
Substance
Hydrogen Sulfide
Iron
AIFII 10 MAXIS O3
8.00
4.00
30
74.4
1
10x54
3.2
Orange
5.0
5.0
1.0
6 to 9
1.0
500.0
Influent Challenge
Maximum Permissible
Concentration
Product Water Concentration
1.0 mg/L +/- 10%
3 to 5 mg/L
AIFII 13 MAXIS O3
8.00
4.00
30
113.4
1.8
13x54
4.2
Dk. Green
8.0
5.0
1.0
6 to 9
1.0
500.0
0.05 mg/L
0.3 mg/L
Requirements for proper
operation:
Water Pressure: The system
will operate on a minimum of 20
psi and a maximum of 100 psi.
Flow Rate: A minimum of 5
gallons per minute is required
for proper system operation. If
less than 0.5 gpm is available,
consult with your dealer for
custom settings or
configurations.
Water Temperature: The range
of water temperature to operate
this system on is 40º to 110ºF.
Drain: A drain should be within
20' of the system using 3/4"
tubing. Maximum overhead
height is 8'. Consult your
dealer for any drain over 30'.
Electricity: An uninterrupted
110 volt AC source is required
to operate this system. Note:
Make sure electrical source is
not on a timer or a switch.
Do not use with water that is
microbiologically unsafe or of
unknown quality without
adequate disinfection before or
after the system.
08/02/21 Rev A
800905
Advertisement
Table of Contents
