Table of Contents
Advertisement
M. Drilling And Cutting Acrylic
DRILLING: Small holes can be drilled with a twist drill,
but the cutting edge MUST be backed off with an oil
stone (the sharp edge dulled). Large holes must be
drilled with a hole saw. Maximum drill size-12mm. Drill
speeds-6mmx1800 RPM-12mmx900 RPM.
NOTE: Always drill from acrylic surface.
CUTTING: If for any reason the acrylic requires cutting,
should happen to be damaged, it can be restored by
polishing with an abrasive cleaner. Deep scratches
can be removed by rubbing with 600 grade wet & dry
sandpaper then polishing.
BATH OPERATION
A. Fill the Bath
CAUTION: Risk of product damage. Ensure
that the area around the blower motor is free
of sawdust, insulation, dirt, or other small loose
debris. Such material could clog the blower
blower motor.
B. Control Switch Operation
��� ������ ���������
Push 1 = blower on
Push 2 = blower off
���� ���� ��� ������ ���� ������������� ���� �� �� ���� ��� ��� �������� ��� ������ �� ����������
C. Preliminary Checks
• Temporarily remove all access panels.
• Verify that the union connection at the check valve is
securely hand tightened.
• Verify that the blower motor is securely installed.
• Verify that the swtich tube is securely connected at
the air switch and at the blower motor.
• Fill the bath to a level at least 50mm above the top of
the highest airjet.
1128227-A01-D Date: 13/8/2010
N. Clean-Up After Installation
• Clean the area around the blower motor of all dust
and debris.
• Use warm water and a liquid detergent to clean the
surface of the bath with airjets. Do not use abrasive
cleaners, as they may scratch and dull the surface.
Do not use powdered cleaners unless the cleaner
is fully dissolved in water. Solid substances
could block the airjets. Do not use bleach or
ammonia cleaning solutions. Chemically active
cleaning solutions can damage the bath surface.
Refer to the homeowners guide for normal cleaning
recommendations.
NOTE: Please read these steps carefully before
you operate your bath with airjets. Troubleshoot any
problems using the "Troubleshooting" section.
12
Advertisement
Table of Contents
