Configuration Options - Ublox EVK-NINA-W13 User Manual

1.7 Configuration options

Module pin IO-
number signal
1 GPIO-23
2 GPI-34
3 GPI-39
4 GPI-36
5 GPIO-32
6,12, 14 GND
7 GPIO-33
8 GPIO-21
9 VCC_IO
10 VCC
13 RF-port
16 GPIO-25
17 GPIO-26
18 GPIO-27
19 RESET-N
Table 8: Module pin to IO signal conversion
(1) Connector/jumper placed inside the brackets indicates that a jumper must be positioned at the
corresponding position of the IO distribution jumpers J14 – J17 if the IO-signal is to be presented at the
designated connector/jumper as mentioned in Table 3.
(2) These IO signals require a second jumper to be positioned at the IO distribution jumper J18 as
mentioned in Table 4.
1.7.1 Power supply
The supply voltage to the EVK-NINA-W13 evaluation board can be sourced from the following connectors:
•
USB (J8)
Depending on your USB source, the USB supply current may be insufficient.
•
External power supply (J23): The external supply voltage must be in the range 5 – 12 V
UBX-17011007 - R04
Primary Accessible at
function Jumper/Connector
J14-5, [J4-5, J7-1]
J2-3
J2-1
J2-2
J2-6, J11-2
J1-6,-7, J4-7, J12-1,-2
J2-5, J5-1, J7-5
J16-1, [J2-4, J7-3]
J25-2
J26-2
Antenna J21
UART_DTR J14-11, [J3-4]
UART_DSR J14-13, [J3-3]
J14-15, [J3-6, J6-1]
RESET (J1-3 via logic)
Module pin
number
( 1 )
20 GPIO-22
21 GPIO-19
22 GPIO-1
23 GPIO-3
24 GPIO-4
25 GPIO-2
26, 30 GND
( 1 )
27 GPIO-0
28 GPIO-5
29 GPIO-18
31 GPIO-14
( 1 ) 32 GPIO-15
( 1 ) 34 GPI-35
( 1 ) 35 GPIO-13
36 GPIO-12
EVK-NINA-W13 - User Guide
IO- Primary
signal function Jumper/Connector
UART_RTS J14-9, [J3-7]
UART_CTS J14-7, [J4-4]
UART_TXD J3-2
UART_RXD J3-1
J16-7
J16-5
J1-6,-7, J4-7, J12-1,-2
J16-3, [J3-8]
J14-1, [J4-3]
J14-3, [J4-6]
J16-9, [J4-2]
J16-13, [J4-1]
J3-5
J16-11, [J4-9]
J16-15, [J4-10]
Accessible at
( 1 )
( 1 ) ( 2 )
( 1 )
( 1 )
( 1 )
( 1 ) ( 2 )
( 1 ) ( 2 )
( 1 ) ( 2 )
( 1 ) ( 2 )
Product description
Page 11 of 20