Advertisement
Quick Links
Quick Start EVK-7PAM / EVK-M8xCAM
1. Overview
E (RS232)
D (USB)
F (RST)
G (Boot)
C (14 pin connector)
Copyright © 2015, u-blox AG
A (RF IN)
Plastic
protection
cover
B (USB / RS232 switch)
2. Setup
1. Download the EVK-7 or the EVK-M8 software (and
documentation) from www.u-blox.com/evk-down-
loads.html and install the software. See installation
notes on back of card.
2. Connect the unit to a PC. Options:
• USB: Connect via USB port (D). Set switch (B) to USB.
The USB driver installs automatically when the device is
connected to a PC - requires internet connection.
• UART: Connect via RS232 (E). Set switch (B) to RS232.
3. Provide power to the device at all times, either via
USB on the back or the V5 IN pin on the front.
4. EVK-7PAM: Place the EVK with good sky view, no
external antenna connectivity at (
EVK-M8QCAM / EVK-M8CCAM: Place the EVK with
good sky view or connect antenna signal to (
5. Start the u-center GNSS Evaluation Software and
select the corresponding COM port and baud rate.
A
).
).
A
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Ublox EVK-7PAM
Summary of Contents for Ublox EVK-7PAM
- Page 1 • UART: Connect via RS232 (E). Set switch (B) to RS232. 3. Provide power to the device at all times, either via USB on the back or the V5 IN pin on the front. 4. EVK-7PAM: Place the EVK with good sky view, no Plastic external antenna connectivity at (...
- Page 2 Windows Start button, (www.u-blox.com/en/ DDC interface (I C compliant) is avail- All Programs > u-blox able for both the EVK-7PAM and the contact-us-support.html). • To uninstall the software, go to EVK-M8xCAM. Control Panel and remove the Additionally, EVK-M8xCAM supports u-center program and “Windows...
Need help?
Do you have a question about the EVK-7PAM and is the answer not in the manual?
Questions and answers