Storage Of Steps; Adjust Leg Extension; Adjust Transport Lock - Lippert Components SolidStep 3.0 Premium Step Owner's Manual

Storage of Steps

1. Retract leg extensions, if desired.
2. Lift up SolidStep® to its stored position and make sure the transport lock has been engaged.

Adjust Leg extension

The leg extension is secured with a quick release clevis pin. Adjustments can be made to the leg extensions
in 1" increments by extending or retracting the inner leg for the optimal angle and to adjust for the ground
surface angle.
1. To extend the inner leg (Fig. 2B):
A. Remove the quick-release clevis pin (Fig. 2A) from the tube and the slot in the angle.
B. Extend the inner leg to the ground and at an angle so the step treads are parallel to the ground
and level.
C. Reinsert the quick release clevis pin into the tube and slot closest to where the inner leg and tube
(Fig. 2C) meet.
2. To retract the inner leg:
A. Remove the quick-release clevis pin from the tube and slot.
B. Retract the inner leg.
C. Reinsert the quick-release clevis pin into the tube and slot.

Adjust Transport Lock

1. If transport lock adjustment is required, loosen the 3 bolts (Fig.3A) on either side of the adjustable
transport lock. This allows adjustment side-to-side in the latch mechanism.
Rev: 07.06.21
Fig. 2
B
A
Fig. 3
A
A
Page 4
C
A
CCD-0004367