Lippert Components Solera Classic Installation Manuals
Awning
Hide thumbs
Also See for Solera Classic:
- Installation and owner's manual (12 pages) ,
- Installation and owner's manual (16 pages) ,
- Oem installation manual (10 pages)
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lippert Components Solera Classic
Summary of Contents for Lippert Components Solera Classic
- Page 1 Solera® Classic Awning OEM INSTALLATION MANUAL...
-
Page 2: Table Of Contents
TABLE OF CONTENTS System and Safety Information Preparation Resources Required Installation Installing the Awning Rail (If Necessary) Assembling the Awning Mounting the Bottom Mounting Brackets Mounting the Awning Securing the Fabric Installing the Stop Bolt Notes System and Safety Information The Solera®... -
Page 3: Preparation
Preparation Do not remove the following items until instructed: • Tape securing the fabric. • Cotter pins in the spring assemblies. Removing these items prematurely may cause personal injury or property damage. Resources Required • 1 to 3 people • ”... -
Page 4: Assembling The Awning
Assembling the Awning Note: The head assemblies (Fig. 3A) and support arm assemblies (Fig. 3B) are numbered to ensure proper assembly. Match the proper support arm assembly to the correct head assembly. On a flat surface, carefully lay out the support arm assemblies and roll tube assembly. The cam lock MUSt be on the right end of the roll tube when facing the unit. -
Page 5: Mounting The Awning
Mounting the Awning Measure the distance from the awning rail channel to the lower mounting bracket fastening point. Compare the distance from the center of the roll tube and the support arm assembly foot to the measurement in Step 1 and adjust the support arm assembly to make both distances equal. A. - Page 6 10. Center the upper mounting brackets on the support arm assembly centerline marked previously and arrange the upper mounting brackets to straddle the awning rail. Tighten the black locking knob on the mount/rafter arm upper channel (channel #3) (Fig. 7). 3/16 11.
-
Page 7: Securing The Fabric
Securing the Fabric Extend and retract the awning several times to ensure that the fabric is square on the roll tube. Secure the fabric in the awning rail no more than 1” inside the edge of the fabric on both ends using a #6 x ”... -
Page 8: Notes
Notes Page 8 Rev: 06.05.18 CCD-0001360... -
Page 9: Notes
Notes Page 9 Rev: 06.05.18 CCD-0001360... - Page 10 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Solera Classic and is the answer not in the manual?
Questions and answers