Table of Contents
Advertisement
ECU BOX INSTALLATION
Mounting the ECU Box
! WARNING:
If the control box is not mounted properly it may fall, causing damage and/or
injury. The Electronic Control Unit (ECU) weight is approximately 40 lbs. Be sure that the
substrate being mounted to and the fasteners being used are appropriate to support the
weight of the control box.
STEP 1
Disconnect the Siren,
Stop Button and EMI
Harness from the Control
Board. Remove the
Control Board Mounting
Plate. The plate is held in
the box by four screws.
1 8
www.PerformanceGateOpeners.com | (800) 878-7829 | Sales@PerformanceGateOpeners.com
STEP 2
Position the ECU Box
in the desired place
and mark the mounting
holes. Prepare the holes
to receive the anchors/
fasteners.
NOTE: Anchors are Not
Supplied.
STEP 3
Position the ECU Box
and secure it to the
mounting surface using
the Sealed Washers
provided (rubber side
of the washers against
the inside of the control
box).
Mounting Fastener
(Customer Supplied)
Sealed Washer
(Supplied with Unit)
Control Box
Mounting Surface
Advertisement
Table of Contents
