How To Assemble Your Light Kit And Ceiling Fan Blades - Fanimation studio AIRE DUO LP8066 Series Manual

How to Assemble Your Light Kit and Ceiling Fan Blades

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly. Retain
the screw for later and slightly loosen the remaining
two screws. (Figure 1)
2. Assemble the lower housing assembly to the
support bracket using the two key slots in the lower
housing assembly. Replace the previously removed
screw and securely tighten all three screws. (Figure 2)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
3. Place a blade on the bottom of a blade holder,
positioning the holes over the threaded posts. Tighten
the serrated-head screws to secure the blade and
blade holder. (Figure 3)
4. Position the blade holder over the motor with
threaded posts showing. Make sure the bottom
edge of the blade holder is fully seated against the
flywheel of the motor. Attach the screws to secure
the blade holder to the flywheel of the motor.
(Figure 4)
Screw (3 per blade)
SERRATED HEAD
SCREW
Motor
SCREWS
12
Motor Assembly
Figure 1
Motor
Assembly
Lower Housing
Assembly
Figure 2
Blade
Figure 3
HARDWARE USED:
x 6
Figure 4
HARDWARE USED:
Blade Holder
Screw
(2 per blade
holder)
Blade Holder