How To Assemble Your Ceiling Fan - Fanimation studio AIRE DUO LP8066 Series Manual

1. Remove the hanger ball
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the black, white and blue wires through the
downrod. (Figure 3)
4. Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)

How to Assemble Your Ceiling Fan

portion from the downrod/
Downrod
Hanger Ball
Hairpin
Clip
Set Screws (2)
Downrod
Clevis Pin
Motor Coupling
Cover
7
Pin
Set Screw
Figure 1
Clevis Pin
Figure 2
Black, White and
Blue Wires
Downrod
Figure 3
Set Screws and
Locking Nuts (2)
Hairpin Clip
Figure 4
Ceiling Canopy
Canopy Screw
Cover
Figure 6