Specifications - Makita CG100D Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Maximum feed force
Feed speed
Stroke
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
This tool is intended for applying caulking material to
surface.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
300 ml size holder
(Holder A)
400 ml size holder
(Holder D)
600 ml size holder
(Holder B)
800 ml size holder
(Holder C)
300 ml size holder
(Holder A)
400 ml size holder
(Holder D)
600 ml size holder
(Holder B)
800 ml size holder
(Holder C)
) : 70 dB(A) or less
pA
D.C. 10.8 V - 12 V max
BL1016 / BL1021B / BL1041B
DC10SA / DC10SB / DC10WC / DC10WD / DC18RE
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
5 ENGLISH
CG100D
5,000 N
0 - 28 mm/s
214 mm
214 mm
350 mm
294 mm
404 mm
402 mm
538 mm
480 mm
1.9 - 2.6 kg