Checking The Height Of The Shoulder Straps; Removing Your Child From The Traveller Plus - Britax Traveller Plus Manual

5

Checking the height of the shoulder straps

6
Shoulder straps
too high
Undo the harness and go to Changing the Height
of the Shoulder Straps on page 6.
6 . The shoulder straps MUST be threaded through the slots in the cover and shell nearest the
top of your child’s shoulders. If in any doubt always use the slot above the shoulder rather
than below it.
Once you reach the top slots your child may continue to use the seat until their eye
line becomes level with the top of the seat shell or their weight exceeds 36kg.

Removing your child from the Traveller Plus

7
5 . Finally, pull both chest pads down from
your child's shoulders onto the chest and
fasten the chest clip. Now check the height of
the shoulder straps as shown below.
IMPORTANT
The chest pads are a safety feature. NEVER
use the Traveller Plus without them.
Shoulder straps
too low
7 . Unfasten the chest clip and loosen the
harness. Then unfasten the buckle by
pressing the red button
To help prevent the harness from twisting,
before you remove your child from the
seat fully slacken the harness and lay the
shoulder straps on the outside of the seat
as shown.
Shoulder straps
at correct height
Undo the harness and go to
Fitting options for the
Traveller Plus on page 9.
5