Changing The Height Of The Shoulder Straps - Britax Traveller Plus Manual

Changing the height of the shoulder straps

1
1 . Turn the Traveller Plus on its side. On
the end of each harness strap is a metal
tab, found under the seat and held in place
by the cover elastic. Undo the elastic.
3
3 . Fold the chest pad so that the chest clip
is in line with the shoulder strap as shown
above. Then push the chest pad and strap
to the back of the seat through the shoulder
strap slot in the cover and the seat shell.
5
5 . Re-thread the strap through the side slot of the cover and seat shell so that the metal tab is
now in its original place under the seat. Re-secure it using the cover elastic. Pull the harness
strap forward to remove any slack. Make sure the harness strap is not twisted and is threaded
through the buckle tongues as shown. Repeat from step 1 above with the other strap.
6
2
1
2
2 . Take hold of one metal tab and turn it
so that the short side will go through the
slot. Push the tab through to the front of
the Traveller Plus.
4
4 . Re-thread the strap and chest pad
through the correct shoulder strap slot in
the seat shell and the cover. Make sure it is
not twisted.
Buckle Tongues
3 4