Programming The Immobilizer System - VESPA Primavera S Manual

supplied to an Authorised Piaggio Service Centre. The codes of keys not submitted
for the new programming procedure are deleted from the memory. Any lost keys will
therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
SHOULD THE VEHICLE CHANGE OWNER, IT IS ABSOLUTELY NECESSARY
THAT THE NEW OWNER GET POSSESSION OF THE KEY WITH THE BROWN
GRIP (AS WELL AS ALL OTHER KEYS).

Programming the immobilizer system (01_47)

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to "RUN".
PROCEDURE START
From the "CLOSE" position, insert the "MASTER" key and turn it to the "ON" position.
Leave the key in this position for 1 to 3 seconds, then return it to the "CLOSE" position
and remove the key.
INTERMEDIATE PHASE
After having removed the "MASTER" key, insert the secondary key to be programmed
within 10 seconds, and immediately turn it to the "ON" position. Leave the key in this
40