Light Switch; Start-Up Button; The Immobilizer System - VESPA S 125ie 3Valvole Manual

Light switch (01_09)

When the light switch «E» is set to «0», the low-beam light is on. When set to «1», the
high-beam light is activated.
CAUTION
DO NOT PLACE, TRANSPORT OBJECTS AND/OR CLOTHES OVER THE FRONT
HEADLIGHT ASSEMBLY, WHEN THE HEADLIGHT IS TURNED ON OR OFF.
01_09
FAILURE TO FOLLOW THIS PRECAUTION MAY CAUSE OVERHEATING AND
THE SUBSEQUENT FUSION OF THE GLASS.

Start-up button (01_10)

To start the engine, pull either brake lever and then press the starter button «F».
The vehicle is equipped with special starter procedure management. The starter motor
remains active until the engine starts even if switch «F» is released.
Keep one of the two brakes operated (front or rear) so as to not interrupt the starter
procedure.
The throttle grip must remain in the minimum position, because any other position
inhibits the vehicle starter.
01_10
The starter motor will remain active for a maximum of 5 consecutive seconds.

The immobilizer system

In order to enhance theft protection, the vehicle is equipped with a «PIAGGIO IMMO-
BILIZER » electronic engine locking device that is activated automatically when the
ignition switch is removed. Upon start-up, the «PIAGGIO IMMOBILIZER» system
15