Programming The Immobilizer System - VESPA GTV 250 i.e. Owner's Manual

Take your scooter to an Authorised Piaggio Service Centre carrying with you the
red-handgrip key and all the blue keys in your possession.
The codes of keys not submitted for the new storage procedure are deleted from the
memory. Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED BY
THE SYSTEM CONTROL UNIT.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF OWNERSHIP OF THE VEHICLE IS TRANSFERRED, THE RED-HANDGRIP KEY
(AS WELL AS THE OTHER KEYS) AND THE "CODE CARD" MUST ALSO BE
TRANSFERRED TO THE NEW OWNER.

Programming the immobilizer system

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to «RUN».
Procedure start - red key
Insert the red-handgrip key in the switch key (in "OFF" position) and turn it to "ON".
After 1 - 3 seconds, turn the key to "OFF" again and pull it out.
Intermediate step - blu key
Within ten seconds after pulling out the red key, insert the black key and promptly turn
it to «ON». After 1-3 seconds, turn the key to "OFF" again and pull it out.
In this way, a maximum of 3 blue keys can be programmed by repeating the above
procedure and keeping the indicated times.
14