Programming The Immobilizer System - VESPA GTS Supertech 300 hpe Manual

cannot be started, an Authorised Piaggio Service Centre with the electronic equip-
ment necessary to identify the problem and repair the system must be contacted.
When requesting additional keys, remember that the registration (up to a maximum
of 3 keys) must be performed for all the keys, including the news ones and those
already in your possession. Take the key with the brown grip and all the blue keys
supplied to an Authorised Piaggio Service Centre. The codes of keys not submitted
for the new programming procedure are deleted from the memory. Any lost keys will
therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
SHOULD THE VEHICLE CHANGE OWNER, IT IS ABSOLUTELY NECESSARY
THAT THE NEW OWNER GET POSSESSION OF THE KEY WITH THE BROWN
GRIP (AS WELL AS ALL OTHER KEYS).

Programming the immobilizer system (01_73)

Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
IZER system and/or for storing other key codes. The programming procedure should
be carried out with the engine stop switch set to "RUN".
PROCEDURE START
From the "CLOSE" position, insert the "MASTER" key and turn it to the "ON" position.
Leave the key in this position for 1 to 3 seconds, then return it to the "CLOSE" position
and remove the key.
51