Remote Control Programming - VESPA Primavera S Manual

Remote control programming (01_49)

To program the new radio commands, do the following:
1. disconnect the battery of the vehicle;
2. reconnect the battery of the vehicle;
3. within 5 seconds of reconnecting the battery, simultaneously press buttons
"1" and "3" on the remote control twice. the «Bike Finder» device will confirm
the process with an optical signal by the quick flashing of the turn indicator;
4. the programming of the new radio command generates the end of the pro-
cedure and the system is ready for use.
01_49
If it is necessary to erase a radio command from the memory of the device, it will be
necessary to repeat the programming 4 times even with the same remote control, in
order to recover the 4 provided memories.
CAUTION
TO STORE THE OTHER REMOTE CONTROLS TO MEMORY (4 MAXIMUM) YOU
NEED TO REPEAT THE WHOLE PROCEDURE AGAIN. FAILURE TO CARRY OUT
THESE OPERATIONS WITHIN THE INDICATED TIMES WILL RESULT IN THE
AUTOMATIC CANCELLATION OF THE PROCESS FOR PROGRAMMING THE
REMOTE-CONTROLLED KEYS. STORING A FIFTH REMOTE CONTROL MAY
LEAD TO CANCELLATION OF THE FIRST ONE.
WARNING
DO NOT KEEP THE REMOTE CONTROL IN PLACES WITH TEMPERATURES
EXCEEDING 60° C THE BATTERY WILL RUN DOWN TOO QUICKLY.
CAUTION
TO AVOID BATTERY DISCHARGE, THE SADDLE OPENING REMOTE CONTROL
RADIO RECEIVER DEACTIVATES 3 MINUTES AFTER THE LAST RECEIPT. TO
43