Default Setting Changes - Toshiba G7 Quick Start Manual

Default Setting Changes

To change a default parameter setting, press ESC until the screen toggles to and from the Frequency
Command screen and the Panel Menu. From the Frequency Command screen, go to the Program
mode by pressing the MON/PRG key twice and the Program menu is displayed. Turn the Rotary
Encoder until the desired parameter group is within the cursor block and press the Rotary Encoder
(repeat if there is a submenu).
Press the Rotary Encoder to select the default setting to be changed and the selection takes on the
reverse video format (dark background, light text). Turn the Rotary Encoder to change the value of the
parameter. Press the Rotary Encoder to accept the new setting or press the Esc key before accepting
the change to exit the menu without saving the change.
For a complete listing of the Program mode menu options, see the section titled Program Mode on pg.
20. Menu items are listed and mapped for convenience. The Direct Access Numbers are listed where
applicable.
The default settings may also be changed by entering the Parameter Number of the setting to be
changed at the Direct Access menu (Program Direct Access Applicable Parameter Number). A
listing of the Direct Access Numbers and a parameter description of each may be found in the G7 ASD
Operation Manual (P/N 51546).
A listing of all parameters that have been changed from the default setting may be viewed sequentially
by accessing the Changed From Default screen (Program Changed From Default).
Note: Parameter F201 was changed to create the example shown in Figure 7.
The Changed From Default feature allows the user to view (or change) the parameters that are
different from the default or the post-reset settings. Once the Changed From Default screen is
displayed, the system automatically scrolls through all of the system parameters and halts once reaching
a changed parameter.
The Rotary Encoder may be clicked once clockwise to continue scrolling forward or clicked once
counterclockwise to begin scrolling in reverse. With each click of the Rotary Encoder from a stop, the
system scrolls and stops at the next parameter that has been changed.
Pressing the Rotary Encoder while a changed parameter is displayed accesses the settings of the
changed parameter for viewing or changing.
Pressing Esc while the system is performing a Changed From Default search terminates the search.
Pressing Esc when done searching (or halted at a changed parameter) returns the system to the
Program Menu.
Figure 7. Changed From Default screen.
G7 ASD Quick Start Guide 13