Table of Contents
Advertisement
Operation (Local)
Note:
See F003 for information on Remote operation.
To turn the motor on, perform the following:
1.
Press the MON/PRG key until the
Frequency Command screen is
displayed.
2.
Press the Local|Remote key to enter the
Local mode (green Local|Remote LED
illuminates).
3.
Turn the Rotary Encoder clockwise
until the Frequency Command value is
at the desired setting.
4.
Press the Run key and the motor runs at the
Note:
The speed of the motor may be changed while the motor is running by using the Rotary
Encoder to change the Frequency Command value.
5. Press the Stop|Reset key to stop the motor.
Default Setting Changes
To change a default parameter setting, go to the root of the Program menu and turn the Rotary Encoder
until the desired parameter group is within the cursor block and press the Rotary Encoder (repeat if there
is a submenu).
Press the Rotary Encoder to select the default setting to be changed and the selection takes on the reverse
video format (dark background, light text). Turn the Rotary Encoder to change the value of the
parameter. Press the ESC key before accepting the change to exit the menu without saving the change or
press the Rotary Encoder to accept the new setting.
For a complete listing of the Program mode menu options, see the section titled
Navigation on pg.
are listed where applicable.
The default settings may also be changed by entering the Parameter Number of the setting to be changed
at the Direct Access menu field (Program Direct Access applicable parameter number). A listing of
the Direct Access/Parameter Numbers and a description of the associated parameter may be found in
the GX7R ASD Install and Op Manual.
A listing of all parameters that have been changed from the factory default setting may be viewed
sequentially by accessing the Changed From Default screen (Program Utility Parameters Changed
From Default).
Note:
Parameter F201 was changed to create the example shown below in
The Changed From Default feature allows the user to view (or change) the parameters that are different
from the default or the post-reset settings. Once the Changed From Default screen is displayed, the
system automatically scrolls through all of the system parameters and halts once reaching a changed
parameter.
The Rotary Encoder may be clicked once clockwise to continue scrolling forward or clicked once
counterclockwise to begin scrolling in reverse. With each click of the Rotary Encoder from a stop, the
system scrolls through the parameters and stops at the next parameter that has been changed.
Pressing the Rotary Encoder while a changed parameter is displayed accesses the settings of the changed
parameter for viewing or changing.
GX7R ASD Quick Start Guide
40. Menu items are listed and mapped for convenience. The Direct Access Numbers
Frequency Command Screen
FRQ CMD
Run Frq:
0.00Hz
Out Cur:
0.00%
Frequency Command
value.
0 . 0
REM
Hz
0 . 0
Program Screen Menu
Figure
21.
33
Advertisement
Table of Contents
