Table of Contents
Advertisement
Figure 93. PHM components
Heat sink
1
Heat sink triangular mark
2
Processor identification label
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• Youku:
https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1.
Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2.
Install the processor-heat-sink module into the system board socket.
ThinkSystem SR860 V2Setup Guide
200
Clips to secure processor in carrier
9
Carrier triangular mark
10
Processor ejector handle
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
Advertisement
Table of Contents
