Install A Processor-Heat-Sink Module - Lenovo ThinkSystem SR860 V2 Setup Manual

Figure 90. Disassembling the expansion tray
Step 3. Separate the expansion board from the supporting tray.
After this task is completed
Recycle the unit in compliance with local regulations.

Install a processor-heat-sink module

The processor and heat sink are removed together as part of a processor-heat-sink-module (PHM)
assembly. PHM installation requires a Torx T30 driver.
About this task
Attention:
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Each processor socket must always contain a cover or a PHM. When removing or installing a PHM,
protect empty processor sockets with a cover.
.
Chapter 5 Server hardware setup
197