Instruction For Use; Introduction; Basic Operations - Labnet I-5222-DS User Manual

BENCHTOP SHAKING INCUBATOR 222DS
4.0 INSTRUCTIONS FOR USE
4.1

INTRODUCTION

POWER
1. POWER switch - switch ON (power switch shines) or OFF the shaking incubator.
2. RUN green signal light - shines when the shaking incubator is running.
3. TEMPERATURE yellow signal light - shines when the shaking incubator is set on
temperature.
4. SPEED yellow signal light - shines when the shaking incubator is set on speed.
5. TIME yellow signal light - shines when the shaking incubator is set on time.
6. ENCODER - with rotating encoder clockwise (+) or counter-clockwise (-), you can
change Time, Speed and Temperature on the shaking incubator. Push encoder to
change between Time, Speed and Temperature.
If you rotate encoder knob fast, the value on display goes up or down quickly.
7. START/STOP key - START or STOP operating.
8. TEMPERATURE display.
9. SPEED/TIME display.
4.2 BASIC OPERATION

Press POWER switch on control panel. Shaking incubator automatically detects
power supply frequency F50 or F60 and shows it on display. Likewise the shaking
incubator is then set to last saved parameters.
POWER
USER'S MANUAL
Page 6