Assembling The Unit - Stihl SR 430 Instruction Manual

3 Assembling the Unit

Vibration behavior is influenced by the condition
of the AV elements – check the AV elements at
regular intervals.
Shut off the engine before rectifying problems.
3 Assembling the Unit
NOTICE
Hose and throttle cable, and the metering unit's
operating cable on the SR 450, come connected
ready for use and must not be kinked while
assembling the machine.
The combination wrench and screwdriver are in
the supplied accessory bag.
3.1 Fitting the pleated hose on the
blower tube
1
► Push wide hose clamp (1), marks facing right,
onto the blower tube (2).
4
► Push the ring seal (3) (wide lip facing left) onto
the stub on the blower tube (2).
► Push the pleated hose (4) over the ring seal
(3).
0458-454-0121-G
2
3 2
4
► Push the hose clamp (1) onto the pleated
hose (4).
► Line up the marks on the hose clamp (1) and
blower tube (2) – as shown.
► Secure the hose clamp (1) with the screw (5) –
the blower tube (2) must still rotate.
3.2 Fitting the pleated hose on the
elbow – SR 430 only
1
2
► Push narrow hose clamp (1), marks facing left,
onto the elbow (2).
► Push the pleated hose (3) onto the elbow (2).
English
2
1
5
3
9